Unisex Mesh Shorts - Size Chart

OUR TAKE - TL;DR

Bad Habbots, LLC. has found the Unisex Mesh Shorts to be true to size, with a classic regular fit, providing a comfortable balance between slim and loose, suitable for various body types, allowing freedom of movement during exercise or adventuring, and elastic waistband and drawstring to adjust as needed without too much pressure.

CIRCUMFERENCE MEASUREMENT - SIZE CHARTS

These charts show the typical circumference measurements based on "Waist" and "Hips". Due to the construction of the shorts, they can be quite flexible - if you typically wear a 34 and want a bit more stretch and longer leg, purchase a size Large (L), if you want a closer fit and shorter leg select a size Medium (M).

SIZE CHART - INCHES 

This size data was obtained manually measuring the product, it may vary up to 1"inch.

SIZE CHART - CENTIMETER

This size data was obtained manually measuring the product, it may vary up to 2.54cm.

 

LINEAR MEASUREMENT - SIZE CHARTS

These charts show the linear measurements based on "1/2 Waist Width" (A), "Front Rise" (B), and "Inseam Length" (C). Due to the elastic in the shorts, they can be quite flexible - if you wear a 34 typically and want a bit more stretch and longer leg, purchase a size Extra Large (XL), if you want a closer fit and shorter leg select a size Medium (M).

SIZE CHART - INCHES

 

This size data was obtained manually measuring the product, it may vary up to 1"inch.

SIZE CHART - CENTIMETER

This size data was obtained manually measuring the product, it may vary up to 2.54cm.

SIZE GUIDE

This size guide shows product measurements taken when products are laid flat. Actual product measurements may vary by up to 1"/2.54cm because they’re custom-made by hand.

 

How to Measure

The measurements provided in the Linear Measurement Tables above show product measurements taken when products are laid flat:

    1. Linear (straight across/up-and-down):
      1. The garment is laid flat and is measured, as depicted in the image above.
      2. "1/2 Waist Width" (A) is measured straight across, left to right, from the top of the waistband above the pockets, as depicted in the picture above.
        1. To get the circumference of the waist you would multiply the "1/2 Waist Width" (A) by 2, this would mean you would get a size you are familiar with such as 32, 34, and so on.
        2. EXAMPLE (inches): The Unisex mesh shorts - SACRED FIRE in XL shows on the size chart a "1/2 Waist Width" (A) measurement of 16 and 1/8 inches, to check this you would lay the garment flat, measure left to right from the seams as described in Point 2 above, which should yield a measurement of 32 and 1/2 inches across for your waist measurement.
      3. "Front Rise" (B) is measured top to bottom, up-and-down, from the top of the waistband to the bottom of the crotch.
      4. "Inseam Length" (C) is measured top to bottom, up-and-down, from the bottom of the crotch to the bottom of the crotch.

     

     

    Bad Habbots, LLC. has provided the above sizing charts from the manufacturer/supplier of the Unisex Mesh Shorts listed on our website. We have compared our ordered samples to the sizing chart provided and found it to be accurate in each of our samples to be tested so far.